Most hot tubs add somewhere between $20 and $60 a month to an electric bill, but the real number depends on the tub, the cover, how cold it gets where you live and how often you soak. Enter your setup below to see your monthly electricity use, what it costs at your rate, and what you’ll spend on chemicals and supplies.
Hot Tub Running Cost Calculator
Estimate your hot tub's monthly electricity use and cost, plus chemicals and supplies.
Check your owner's manual for the exact number, or work it out with our Hot Tub Volume Calculator. Most hot tubs hold 250 to 600 gallons.
High-efficiency means full-foam insulation and a tight, thick cover. Pick "Old / Worn" if the cover is waterlogged, sagging or leaks steam.
Use the average for the months you're estimating. Run it twice, with summer and winter temperatures, to see the range.
Find it on your electric bill: total charges divided by kWh used.
Estimated Electricity Cost
$/mo
About kWh a month ( kWh a day)
Total Monthly Running Cost
$
About $ a year if conditions stayed like this all year.
A better cover could save about $ a year
Heat escaping through the cover is the biggest part of most hot tub electric bills. A thick, tight-fitting replacement cover often pays for itself in a few seasons.
Shop Hot Tub Covers on Amazon →Need exact chemical doses for your tub? Try our Hot Tub Chemical Calculator.
How Much Does a Hot Tub Cost to Run Per Month?
For a typical 400-gallon hard-shell hot tub with a decent cover, kept at 102°F and used a few times a week, the calculator lands around $30 to $40 a month in electricity at 17 cents per kWh, plus about $25 a month in chemicals, filters and water. Here’s how the electricity side shifts with climate and cover condition for that same tub:
| Setup (400 gallons, 4 soaks a week) | Electricity per Month | kWh per Day |
|---|---|---|
| Warm climate, standard cover | about $28 | about 5.5 |
| Mild climate, high-efficiency cover | about $30 | about 6 |
| Mild climate, standard cover | about $39 | about 7.5 |
| Cold climate, standard cover | about $56 | about 11 |
| Cold climate, old or worn cover | about $81 | about 15.5 |
These come straight from the calculator’s defaults at $0.17 per kWh. If your rate is higher or lower, the cost scales in step: at $0.34 per kWh, every number in the middle column doubles.
What Uses the Electricity
Keeping the Water Hot
The heater is the biggest load by far. Even with the cover on and nobody in it, a hot tub is a few hundred gallons of 100°F-plus water sitting outside, and it loses heat through the cover, the shell and the cabinet around the clock. The heater cycles on to replace that heat, and the colder the air, the harder it works. That’s why the same tub can cost twice as much to run in January as it does in July.
The calculator starts from the California Energy Commission’s standby-power benchmark for portable spas, which scales with water volume, then adjusts for how well your tub and cover hold heat and for the gap between your water temperature and the outdoor air.
Filtration and Circulation
Most tubs run a circulation pump on a schedule (or a small 24-hour pump) to keep water moving through the filter. On a modern tub this is a modest load, and it’s included in the calculator’s “keeping it hot and filtering” line.
Running the Jets
Jet pumps draw far more power than the circulation pump, often 1.5 to 2 kW or more on a hard-shell tub, but they only run while you’re soaking. Four half-hour soaks a week adds a few dollars a month.
Reheating After You Soak
With the cover off, a hot tub loses heat quickly, especially on a cold or windy night, and the heater has to make it back up after you close the lid. Longer, more frequent soaks in cold weather push this line up. Closing the cover as soon as you get out helps.
Hard-Shell vs. Plug-and-Play vs. Inflatable
Hard-shell 240V tubs usually have the most insulation and the strongest heaters. They cost more up front but tend to be the cheapest to run per gallon, especially in cold climates.
Plug-and-play 120V tubs plug into a standard outdoor outlet, which saves on electrical work. Their heaters are smaller, so they recover more slowly after a soak, and many models have less insulation than full-size tubs.
Inflatable hot tubs are the cheapest to buy and the most expensive to keep hot. Thin vinyl walls and lightweight covers let heat escape much faster, so a small inflatable can use as much electricity as a full-size hard-shell tub, or more. In freezing weather, many inflatable heaters can’t keep up at all, which is why a lot of owners drain and store them for winter.
Chemicals, Filters and Water
Beyond electricity, plan for sanitizer (chlorine or bromine), pH and alkalinity balancers, test strips, replacement filter cartridges and periodic drain-and-refills. Most owners spend roughly $20 to $35 a month on these depending on tub size and how often it’s used. The calculator adds a flat amount based on your water volume.
How to Lower Your Hot Tub Electric Bill
- Fix or replace a worn cover. A cover that’s waterlogged, cracked or no longer seals is usually the single biggest energy drain. The calculator shows what a better cover could save you each year.
- Keep the cover on and latched. Close it as soon as you get out, and make sure the edges seal all the way around.
- Lower the temperature when you’re away. Dropping a few degrees for a week-long trip cuts standby heat loss. For longer stretches, use your tub’s vacation or economy mode.
- Block the wind. A privacy screen, fence or plantings on the windward side reduce heat loss from the cover and while you soak.
- Run filtration off-peak. If your utility has time-of-use rates, schedule filter cycles and heating for cheaper hours.
- Add a floating thermal blanket. An inexpensive foam or bubble blanket under the cover adds another layer of insulation.
Frequently Asked Questions
How many kWh does a hot tub use per day?
A well-insulated hard-shell hot tub in mild weather typically uses around 5 to 8 kWh a day, including heating, filtration and a few soaks a week. Cold climates, worn covers and inflatable tubs can push that into the teens.
Is it cheaper to leave a hot tub on all the time?
For most hard-shell tubs, yes. Keeping the water near your soaking temperature with a good cover on usually costs less, and is far easier, than letting it cool all the way down and reheating hundreds of gallons from cold. Lowering the setpoint a few degrees between uses is a reasonable middle ground.
Does a hot tub cost more to run in winter?
Yes. The colder the outdoor air, the more heat the tub loses and the more the heater runs. Run the calculator once with your summer temperature and once with your winter temperature to see your range for the year.
How do I find my exact hot tub electricity cost?
Compare a month of electric bills with the tub running against the same month the year before, or have an electrician install an energy monitor on the tub’s circuit. Plug-and-play tubs can be measured with a heavy-duty plug-in energy meter rated for the load.
How much does a hot tub cost per year to run?
For a typical hard-shell tub, electricity plus chemicals and supplies often adds up to roughly $600 to $1,000 a year. A tub in a cold climate with an old cover can run well over $1,200.